Skip to content

Integrate u-boot-seco-rk/ap/fix-dp83867-driver

GitBot requested to merge u-boot-seco_2017_09_next/ap/fix-dp83867-driver into kirkstone

Commit: edgehog/bsp/rockchip/u-boot-seco-rk@996ee5af

[DRIVERS] Enable support for setting up DP83867 leds

Based on kernel commit edgehog/bsp/rockchip/linux-seco-rk@36e6025f

--

Commit: edgehog/bsp/rockchip/u-boot-seco-rk@438ca97e

[DRIVERS] net: phy: dp83867: rework delay rgmii delay handling

Based on this commit: edgehog/bsp/nxp/u-boot-seco-imx@20f7ea4c

Based on commit c11669a2757e ("net: phy: dp83867: Rework delay rgmii delay handling") of mainline linux kernel.

The current code is assuming the reset default of the delay control register was to have delay disabled. This is what the datasheet shows as the register's initial value. However, that's not actually true: the default is controlled by the PHY's pin strapping.

This patch:

  • insures the other direction's delay is disabled If the interface mode is selected as RX or TX delay only
  • validates the delay values and fail if they are not in range
  • checks if the board is strapped to have a delay and is configured to use "rgmii" mode and warning is generated that "rgmii-id" should have been used.

Signed-off-by: Grygorii Strashko grygorii.strashko@ti.com Acked-by: Joe Hershberger joe.hershberger@ni.com

--

Commit: edgehog/bsp/rockchip/u-boot-seco-rk@170c7568

[DRIVERS] net: phy: dp83867: switch to use ofnode api

Based on: edgehog/bsp/nxp/u-boot-seco-imx@3ab75cf7

Switch to use more generic ofnode API instead of FDT API.

Merge request reports