Skip to content

[i.MX8][C26] Add basic support for C26 Q7 module

Davide Cardillo requested to merge seco/lf_v2021.04/bring_up_c26 into seco/lf_v2021.04/develop

Tested configuration: 8GB

Supported peripherals:

  • serial debug
  • eMMC
  • uSD x2
  • TI DP83867

U-Boot SPL 2021.04-00025-gdfc06478-dirty (Nov 29 2021 - 11:56:03 +0000) Normal Boot Trying to boot from MMC2_2 Primary set selected Load image from MMC/SD 0x68c00 U

U-Boot 2021.04-00025-gdfc06478-dirty (Nov 29 2021 - 11:56:03 +0000)

CPU: NXP i.MX8QM RevB A53 at 1200 MHz at 26C

Model: SECO i.MX8QM C26 Board: SECO iMX8QM C26 Boot: SD1 DRAM: 6 GiB MMC: FSL_SDHC: 0, FSL_SDHC: 1 Loading Environment from MMC... OK Fail to setup video link In: serial Out: serial Err: serial

BuildInfo:

  • SCFW b821f957, SECO-FW 27167ff2, IMX-MKIMAGE 3a0b2f0f, ATF 70fa7bc
  • U-Boot 2021.04-00025-gdfc06478-dirty

davide ----- 4 switch to partitions #0, OK mmc1 is current device flash target is MMC:1 Net: eth0: ethernet@5b040000 [PRIME] Fastboot: Normal Normal Boot Hit any key to stop autoboot: 0 MX8M SECO U-Boot >

Merge request reports